Hi 96M331,


I saw your car on the forums and thought I would drop you a note to ask you a very important question.


How much hood clearance do you have with your trickflow intake manifold ? Did you do anything special with the subframe (lowering spacers etc) to get it to fit? Did you have it machined? If so by how much ?


Could you be kind enough to advise what the dimension is from the block surface of the manifold end rails to the top of the intake manifold you have in mm or inches?


I wish to fit a TFS R intake on my build but as its 0.8 inches TALLER than the TFS street burner/track heat manifold, I am hesitant...as I don't want to use a hood scoop.


Any advice or guidance would be greatly appreciated


Cheers
John